Irwanto Zarma Putra S.Pd. M.EngDiono S.Tr. T., M.ScDewa Kurnia Sandy2024-12-302024-07-17APAhttp://103.209.1.147:4000/handle/PL029/2702Full page Artikel, Berkas pendukung, Borang publikasiAbstract—as the years go by, there are many innovative developments in various fields, including the health sector, especially in medical devices themselves. One of the conditions for medical equipment to be used is to look at the condition of the equipment, its suitability for use, sterilization and standardization of the equipment. If the condition of a medical device does not meet the requirements, then the use of the device is certainly not recommended. Because this will have a negative impact on the medical process. Therefore, this research will create a machine that can carry out the stamping or marking process in the production process of transfusion set equipment. The purpose of marking the transfusion set device is to mark the locking direction of the device itself, which will make it easier for medical personnel to carry out medical procedures. The method used in this research is to apply the principle of a pneumatic drive system and PLC as a control system for this tool. Apart from that, the design of this tool also aims to determine the impact of using Hot Stamping on materials made from PVC plastic, and analysis of the results of the process can be carried out. In this research, the analysis process carried out on the set transfusion hose will use the Quantitative Descriptive analysis method on the stamping temperature, then the data from the results of this analysis will be used to determine the optimum temperature value and stamping duration that should be used for the stamping process in the production process. Keyword: Medical Devices, Pneumatic Systems, PLC, Rotary Encoder.enTECHNOLOGY::Materials science::Functional materialsBookNIM4211811028NIDN0004088902NIDN0015119302KODEPRODI21312#TEKNIK MEKATRONIKA